Welcome to the Austin Seven Friends web site and forum

As announced earlier, this forum with it's respective web address will go offline within the next days!
Please follow the link to our new forum

http://www.austinsevenfriends.co.uk/forum

and make sure, you readjust your link button to the new address!

Welcome Austin seven Friends
This Forum is Locked
Author
Comment
King Pin Bushes

I have fitted new kingpin bushes to the stub axles for my 1929 RK saloon and reamed them with a 1/2" reamer courtesy of A7 Components. All fine and the reamer goes through, but when I try to put a king pin (also new also courtesy of A7 components) through it gets jammed? I have measured the king pin and it's fine, exactly 1/2" The reamer is a long one and goes through both stub axle bushes.

So how come the king pin jams and what can I do about it? I wondered about lapping it in with a bit of fine valve grinding paste?

Thanks

Location: Northumberland

Re: King Pin Bushes

Alan,
Attach an old 5/16" BSF head stud onto the tapped end of the kingpin and stick it in your lathe or drill on slowest speed,apply lots of engine oil to pin and bushes in the stub axle and gently (very gently) feed the stub axle onto the pin. Be prepared for it to grab so be very careful. Keep pulling them apart and adding more oil. My dad showed me how to do this. He was a fitter for over 50 years.Please be careful!
Dave.

Location: Sheffield

Re: King Pin Bushes

So basically lapping in the king pin, just not with a grinding paste just with engine oil?

Location: Northumberland

Re: King Pin Bushes

Has anyone found the original specs for kpins? I suspect -.001 to run in a standard .5 inch hole, although new reamers are usually a shade oversize and may cut accordingly. All the very old used and new kpins I have are under .5 inch.

So many axles eyes are loose a shade extra pin diameter is useful.

The kingpin may distort slightly when in the axle so a super close fit in bushes before can prove too tight and awkward to fix if the pin chances to be very tight in the axle. Must be free in car; loosen eventually but car will wander meanwhile and risk of bushes turning in hubs. Abrasive materials tend to bed in the bronze and cause ongoing wear.

Trust you have perused most of the previous kingpin posts.

Location: Auckland, NZ