Welcome to the Austin Seven Friends web site and forum

As announced earlier, this forum with it's respective web address will go offline within the next days!
Please follow the link to our new forum

http://www.austinsevenfriends.co.uk/forum

and make sure, you readjust your link button to the new address!

Welcome Austin seven Friends
This Forum is Locked
Author
Comment
Front bearing lip

Whilst on the Euro tour a noise started at the front end of the engine, couldn't identify it for some time. The noise happened on an incline or when pulling away. Eventually realised the the starter shaft in the nose cone was engaging, the spring must be broken. Held it out with insulating tape,job done. As the car had spent its hols spreading 3 ltrs of oil even all over Europe I decided to fit one of the new silicon washers between block and crankcase. This is what I found. I think that the shaft had been working like a jack hammer.




[

Next job strip down engine and fit a new steel lip

Location: Oakley, hants

Re: Front bearing lip

All too common I am afraid Derek, many apparently intact flanges are actually cracked, I would encourage all when building an engine to at the very least test the flange, I almost routinely replace the flange these day's.

Location: NZ

Re: Front bearing lip

Derek - If I recall correctly, Ian Dunford is one who can help you in this regard. Good Luck, Cheers, Bill

Location: Euroa, Australia

Re: Front bearing lip

I am very fortunate in having friends near bye , Martin Baker and Chris Surtell. Martin for the appropriate tooling and Chris although a ten driver, probably knows more about the workings of a seven than your average owner having spent two mornings a week over seven years in my garage. I am sure the problem will be shortly rectified. I spent the morning stripping the engine down to its component pieces ready to start on Friday.
But of course one cannot forget the friends on here who have contributed over many many years. Thanks.

Location: Oakley, hants

Re: Front bearing lip

Hi Derek,
Front bearing lip repair kit available from David Cochrane A7 components
Vince

Location: MOONRAKER COUNTRY

Re: Front bearing lip

Many thanks

Location: Oakley, hants