Welcome to the Austin Seven Friends web site and forum

As announced earlier, this forum with it's respective web address will go offline within the next days!
Please follow the link to our new forum

http://www.austinsevenfriends.co.uk/forum

and make sure, you readjust your link button to the new address!

Welcome Austin seven Friends
This Forum is Locked
Author
Comment
View Entire Thread
Re: Clutch plate rivets

Ivan.
I hope you did not crack the flange on the splined centre by hitting it too hard. I am speaking of experience!
Dave.

Location: Sheffield

Re: Clutch plate rivets

I'm pretty good with a hammer as when I was about 3 yrs old my father gave me a hammer, a block of wood and a tin of nails, to keep me out of mischief. Soon I couldn't see the wood for the nails.
Anyway, the Bantam has a plain disc exactly like early A7, but the splined centre is thick, strong, tough and female. (I'd better say no more in case the digital nanny notices)

Location: Wellington, NZ

Re: Clutch plate rivets

A complication is that the holes are often very oval, which means even home turned rivets do not suit. I have not tried on these parts but have been told by one long experienced Seven authority that a carbide drill can be used to reform the holes. Of course all a waste of time if the splines worn.

Worn rivets or splines lead to a clacking noise esp at low speed in top as the drive alternates.

Location: Auckland, NZ