Welcome to the Austin Seven Friends web site and forum

As announced earlier, this forum with it's respective web address will go offline within the next days!
Please follow the link to our new forum

http://www.austinsevenfriends.co.uk/forum

and make sure, you readjust your link button to the new address!

Return to Website  > Index
Recent Posts
 
Welcome Austin seven Friends
This Forum is Locked
Author
Comment
View Entire Thread
c
Colin Reed
Apr 17, 2017 - 10:07PM
Re: clutch pressure plate

Hi Ken, That looks fine, but I would Skim the pressure plate.
there are a couple of things to watch
If being done in a lath you will probably need to take at least a 10th cut first up as the surface will have hardened and you need to get underthat in one go it will only be necessary to take out about 85% of the marks.
This will not have any detrimental Effect on the Plate,
And as you are rebuilding the Engine that is the way to go

good Luck Colin

Location: TINOPAI NZ

Email  
Apr 17th, 2017 - 10:07 PM
k
Ken Dart
Apr 18, 2017 - 8:39AM
Re: clutch pressure plate

Hi Colin .I am thinking the same, I have a boxford lathe with a 9"swing so it will fit.Thanks for your advice.
ken

Location: France

Email  
Apr 18th, 2017 - 8:39 AM
n
Nick Turley
Apr 18, 2017 - 6:28PM
Re: clutch pressure plate

I agree with Colin, facing it off seems the correct solution.

Location: The Centre of the Universe

Email  
Apr 18th, 2017 - 6:28 PM
Return to Website  > Index