All ball bearings have internal clearance even when new. A two ball hub as with the Austin 7 must always have some slack and as Bob says the outer bearing should be free to float endways in the hub, with the inner bearing doing the locating.

If you can find two new good quality bearings with reduced internal clearance (SKF C2, R&M/RHP two dot)), which is unlikely now, then the movement could be reduced slightly.

If the bearings are loose in the hub or on the stub axle this will exaggerate the wobble.

The inner bearing must be a snug fit in the two parts of the housing and on the stub axle, the outer bearing a sliding fit in the hub and on the stub axle. I wouldn't suggest Locktite which will give problems later when dismantling.

If sealed bearings are used (recommended) then the felt plate must still be used.

Originally a paper gasket was used between the two hub halves- any thicker will lose the side retention.

I believe race scrutineers often complain about Austin 7 front wheels, being used to two taper roller assemblies but as noted a front hub with two ball bearings will always have a slight slackness.

Chewers, Tony.

Location: Melbourne, Victoria, Australia.

Are you sure that it is the wheel bearings and not axle eye wear/elongation. Your king pin and bearings may be perfect but the eye in the beam may be out of shape ( a common problem with Austin Sevens)

Thanks to you all - a pretty comprehensive answer. I reckon its Loctite on the inner bearing to start with. At the same time I will take the opportunity of replacing the wheel studs as the old ones are the originals.
Bob

Location: France Dept 46

Bob,
Your tester unfortunately is mistaken. The exemption which came into force in February this year relates to all cars with Carte Grise Collection first registered before 1/1/1960. Later cars still have to have the 5 yearly test.

If there is an insurance requirement that's a private matter between the owner and the insurer and in any case it's voluntary. My classic insurer certainly has made no contact regarding this.

If you need documentary proof there is a link to the legislation on the FFVE.fr website.

Good Luck
Bruce

Turned up for the CT this AM, and the tester was surprised to see me. He checked the docs and as Reckless said. No requirement for the test as it was pre '60 and a "light Vehicle". It was his boss that had said the test was required. So I went home with a smile having saved 59 euro - then my wife said the dish washer had packed up. On inspection, the computer was burned out and as it was over 12 years old, so it was off to buy another one. Some you win and some you loose.

Location: France Dept 46