I am struggling to source:

1. RN sliding roof end caps (they stop the roof from coming all the way off).

2. The little hollow grub-screws, springs and v-clamps that go inside the control levers (adv./ret. & throttle).

I have bought these new in the past but cannot remember where from, anyone know please??

hi R,

i have the cup, spring, and brass V for the advance and retard in stock.

dont know if anyone else makes them.

tony

Location: in a disgruntled place

Believe tony used to do the advance and retard set
Bob

Location: Surrey

Thank you both. Tony - email on its way to you.

The last sliding roof end caps I bought were cast aluminium, I think...

I bought a pair some years ago from John Barlow, which needed a bit of fettling to finish them. I think they were brass.
Regards,
Ashley

Thank you Ashley.

I do the grub screw set, as well

Location: Near junc 8. M25

Thank you Jon.

I bought some cast Sliding roof stops from John Barlow some time ago. I also seem to remember that some ABS ones were available from either Geoff Roe or Dave Mann, the latter who could probably advise you definitely.

I had some Plastic vac formed ones from, I think Geoff Roe. Remember that there are a pair of steel blocks fixed to the roof which are threaded for the screws to hold the caps on. About 3/4 square and 3/16th thich. Mine were missing

Location: Relaxing

Thank you Pete and Andy.

Luckily the threaded blocks still exist on the car I need the caps for.